Plasti Dip Primer

Plasti Dip Primer is an air-dry acrylic primer specifically formulated to increase the adhesion of Plasti Dip to metals by up to 400%.

Plasti Dip Primer can be sprayed, dipped, or brushed while offering a fast setup time.  Typically applied in one coat, only extreme corrosion and abrasion require a second or third coat.  Eliminating extensive preparation for most applications.  Plasti Dip Primer is recommended on all metal surfaces, especially galvanized, to prevent peeling of Plasti Dip.

For best results apply Plasti Dip over Primer.

Plasti Dip Primer is not recommended to be used as a protective coating on its own.

Plasti Dip Primer Part Numbers

Surface Preparation for Plasti Dip Primer

Mix well before before use.  Try to avoid forming bubbles in primer while mixing.  Make sure surface to be coated is free of any oils, dirt, rust, or other contaminants.  A sandblasted or rough surface allows for best adhesion of primer. 

Always use adequate ventilation

Spraying Plasti Dip Primer

Pressure pot/conventional spray equipment may be used.

Dilute with recommended thinners as needed.  Gently mix before spraying.  Apply wet, overlapping coats while holding gun 6"-12" from surface.  Allow 10-20 minutes drying time before applying additional coats to desired thickness or before applying Plasti Dip,

Always use adequate ventilation

Recommended Equipment and Settings

Binks Model 62 Gun

Nozzle:  63B

Cap:  63PB

Needle:  363-A

Material:  15-25 psi

Atomization:  15-25 psi

Dilution:  as needed

Clean up:  Plasti Dip Thinner

Industrial/Commercial airless equipment may be used

Tip size: .011 -.019

Pressure: as needed

Dilution: as needed

Dipping Plasti Dip Primer

Dilute with recommended thinners as needed.  Gently mix before each use.  Do not introduce air bubbles.  Insert item 1" every 5 seconds.  Remove at same rate.  Allow 30-40 minutes to dry before applying Plasti Dip

Always use adequate ventilation